DIY_EFI Digest              Monday, 8 July 1996        Volume 01 : Number 192

In this issue:

	Re: G-Force Measurement

See the end of the digest for information on subscribing to the 
DIY_EFI or DIY_EFI-Digest mailing lists.

----------------------------------------------------------------------

From: Brad Sheridan <bs73@xxx.edu>
Date: Mon, 8 Jul 1996 01:37:10 -0400 (EDT)
Subject: Re: G-Force Measurement

 
Tim,
 Sounds like a good system. In case you were wondering which accel. we are
using, its the IC sensors one mentioned in a previous post, and we're
getting it arould $90 in large quantity(Dont know exactly what large is
though). I was wrong about the reason for not using the AD accel. but now I
can't remember what Helmut told me. I know one of the reasons is that for a
device like what we have, people expect something to be 'instant on' and the
AD required warm up. I also think its lacking in accuracy, and possibly the
range of measurement. How much do you have wrapped up in the production of
your unit? $600 seems awfully low when you figure in hardware prices, and
the fact that you'll be doing tech support for it, dealing with returns,
defective units, overhead of inventory, etc.

Good Luck,
Brad

------------------------------

End of DIY_EFI Digest V1 #192
*****************************

To subscribe to DIY_EFI-Digest, send the command:

    subscribe diy_efi-digest

in the body of a message to "Majordomo@xxx.  

A non-digest (direct mail) version of this list is also available; to
subscribe to that instead, replace "diy_efi-digest" in the command
 above with "diy_efi".