DIY_EFI Digest Sunday, 28 February 1999 Volume 04 : Number 137 In this issue: Re: Code Work See the end of the digest for information on subscribing to the DIY_EFI or DIY_EFI-Digest mailing lists. ---------------------------------------------------------------------- From: "Peter Fenske" Date: Sun, 28 Feb 1999 01:42:33 -0800 Subject: Re: Code Work Howday Bruce Lookin at your injector pages confirms most of the stuff we have heard about injectors.. Like the disc type locking up under too much pressure.. Also mechanical inertia effects, oscillations, make the first two millisecs difficult to correlate.. funny thing I see though is some injectors with a greater slope gms/sec figure that gm uses flow less than some other injectors with a greater slope figure.. Seems to depend where they stabilize after the first two millisec.. I would really apreciate that MAF. what can you use/want for it.. Have a few tons of junk around here.. How goes the TPI conversion. I think David or Terry sent me that file before.. Some where lost in the abyss that is my harddrive or stack of CD roms I think. Handy stuff though. You can put the variables in a dissembler for most gms.. well gl, hope all goes well, ect ect:peter ------------------------------ End of DIY_EFI Digest V4 #137 ***************************** To subscribe to DIY_EFI-Digest, send the command: subscribe diy_efi-digest in the body of a message to "Majordomo@xxx. A non-digest (direct mail) version of this list is also available; to subscribe to that instead, replace "diy_efi-digest" in the command above with "diy_efi".