DIY_EFI Digest Monday, July 26 1999 Volume 04 : Number 433 In this issue: Knocksensing with HIP9010/9011 See the end of the digest for information on subscribing to the DIY_EFI or DIY_EFI-Digest mailing lists. ---------------------------------------------------------------------- Date: Mon, 26 Jul 1999 17:56:51 +0200 From: "Nils Björkman" Subject: Knocksensing with HIP9010/9011 Hi I am designing my own ignition system right now and are planing to use the Harries HIP9010 or HIP9011 knock sensor chip. Does anyone know anything mor than the datasheet says???? How to decide what to choose 9010 or 9011 ? Is the basic circuit in the datasheet enough ? What parameters should I start with in the different registers ? How to make tests and evaluation quickest and easiest ? My engine is a Volvo B230F: 4 cylinder cast iron block with aloy head Overhead camshaft Displacement 2.3 liters RPM range 600 to 6000 rpm aprox power 150-160 hp Fuel injection (214 ml/min injectors) Knocksensor BOSH 0 261 237 006 mounted in top center of the engine block (just below the head) Does anyone have any suggestions pleas let me know via this list or direct mail to: nisse@xxx.se Best regards Nils Björkman ------------------------------ End of DIY_EFI Digest V4 #433 ***************************** To subscribe to DIY_EFI-Digest, send the command: subscribe diy_efi-digest in the body of a message to "Majordomo@xxx. A non-digest (direct mail) version of this list is also available; to subscribe to that instead, replace "diy_efi-digest" in the command above with "diy_efi".