Why does the RUNB command stop before the next breakpoint?

The RUNB command enables the hardware breakpoint features of the analysis module. Therefore, if you do not wish to stop at a different breakpoint either:

  • Disable the hardware breakpoints by issuing the command: E HBPENBL=0.
  • Pull down the menu Analysis and select the Break entry. In the dialog window, disable all the break events that you do not want to break on.
    Device: TMS320C5xx
    Category: TI Tools
    Detail: Debugger Tools
    Detail2: General    		 Title: RUNB Command Stops
    Source: Case from the TMS320 Hotline
    Date: 4/25/98
    GenId: a2

    © Copyright 1998 Texas Instruments Incorporated. All rights reserved.
    Trademarks, Important Notice!