MSP430 Tools and Software

Hardware Tools

• USB Debugging and
  Programming Interfaces
• MSP430 Parallel Port
  Debugging Interface
• Starter Kits: Programmer
  + Target Board + IDE
• Target socket Boards
• Gang430
• Experimenter Boards
• eZ430™ Development Tools

Software Tools

• Code Composer Studio v4
• IAR Embedded Workbench

Web Resources

• MSP430 Home
• eZ430 Home
• Code Examples
• Training
• Application Notes
• MSP430 Brochure
• MSP430 and Wireless

MSP430 Parallel Port Debugging Interface 

The MSP-FET430PIF is a Parallel Port interface (does not include target board) that is used to program and debug MSP430 FET tools and test boards through the JTAG interface. This interface is included in our FET tools, but sold without the development board. This interface uses a Parallel PC Port to communicate to the Debugger Software (IAR Kickstart software included) running on the PC. The interface uses the standard 14 pin header to communicate to the MSP430 device using the standard JTAG protocol.

MSP-FET430PIF

The flash memory can be erased and programmed in seconds with only a few keystrokes, and since the MSP430 flash is extremely low power, no external power supply is required. The tool has an integrated software environment and connects directly to the PC which greatly simplifies the set-up and use of the tool. The flash development tool supports development with all MSP430 flash parts.

Features

• MSP430 debugging interface to connect a MSP430-Flash-device to a Parallel port on a PC
• Supports JTAG debug protocol (NO support for Spy-Bi-Wire (2-wire JTAG) debug protocol, Spy-Bi-Wire (2-wire JTAG) is supported by MSP-FET430UIF)
• Technical specifications:
  • Backwardly compatible with existing FET tool boards.